To show transceiver temp and light levels: #show hw-module interface g0/0/1 transceiver status.

switch (config)# no errdisable detect cause gbic-invalid.

To remove a line card, use the figure below or Figure 2 as a reference and follow these steps: 1. The Cisco ASR 1000 Series Aggregation Services Routers are designed to send alarm notifications when problems are detected.

Print Results.

switch (config)# service unsupported-transceiver.

Module temperature = +37. Cisco has updated its platforms and minimum software releases that support the Gigabit Interface Converter (GBIC) and Gigabit Ethernet Small Form-Factor Pluggable. switch (config)# no errdisable detect cause gbic-invalid.

The following is a sample output of the show hw-module subslot transceiver status command on a Cisco ASR 1000 Series Router with the Cisco ASR 1000 Series.

. . • Network Administrator Checks Console or Syslog for Alarm Messages.

and erial-no. reinsert module.

On our new ASR I was looking for a command similar to “show interface XXX transceiver”, but that didn’t exist.

Network administrators do not need to use show commands to poll devices on a routine basis and can monitor the network remotely.

Network administrators do not need to use show commands to poll devices on a routine basis and can monitor the network remotely. IOS-router#show hw-module subslot x/x transceiver x status.

show inventory shows you the device components, part-no. and erial-no.

The router is rejecting an unsupported, third-party module.
The transceiver in slot 0 subslot 0 port 6.
Cisco ASR 901 threshold logic.

5um), Diagnostic support : DOM Serial number : MY050VM9WB Status Temperature : 50.

Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Here are the commands I found relevant to the ASR: To show transceiver hardware details: #show hw-module interface g0/0/1 transceiver idprom. . When I removed the command, I got some log messages:.

show interface shows all interfaces (which may have a protocal attached, for example, IPv4). . subinterfaces ( gig 0/1. To show transceiver temp and light levels: #show hw-module interface g0/0/1 transceiver status. show inventory shows you the device components, part-no. The example shows a critical alarm for Power.

To view the alarms on Cisco ASR 1001 router, use the show facility-alarm status command.

No surprise there that a device accepts a command and does fuck all with it. .

I am trying to bring up some 3rd party Bi-Di transceivers in an ASR 1001-X.

Chapter Title.

.

I need some help as i am very frustrated with a a very simple situation here.

In Cisco c ompatibility matrix this SFP are supported by ASR 1000 series but when i'm connecting one I've got following message in logs: *Oct 29 06:09:49.